Thermaltake P1000 Pastel Coolant – Turquoise Thermaltake P1000 Pastel Coolant – Turquoise Thermaltake P1000 Pastel Coolant – Turquoise Thermaltake P1000 Pastel Coolant – Turquoise
Thermaltake P1000 Pastel Coolant – Turquoise

Thermaltake P1000 Pastel Coolant – Turquoise

在庫あり
P/N
CL-W246-OS00TQ-A
USD$39.99
1000ml Turquoise pastel based non-transparent and high performance coolant for PC water-cooling, offering superb protection for copper, nickel, brass, and aluminium.
 
Better Formula, For a Better System

Anti-Corrosive Solution

Protects copper, brass, nickel, and aluminum.

Antifreeze

Ensures coolant to run effectively under extreme weathers.

Liquid Surface Tension Optimizer

Helps minimizes the risk of an airlock; with the Liquid Surface Tension Optimizer, P1000 only takes about 5 to 10 seconds when starting the system for the first time after filling the loop.

Low Viscosity Enabler

Low viscosity allows the P1000 Pastel Coolant to travel through the loop faster, thus dispatching the heat more effectively.
 
 
 

Coolant Viscosity at 20°C(m Pa‧s)

  • P1000 Pastel Coolant> 1.42m Pa‧s
  • Other Coolant> 1.93m Pa‧s

Coolant Viscosity at 40°C(m Pa‧s)

  • P1000 Pastel Coolant> 0.89m Pa‧s
  • Other Coolant> 1.2m Pa‧s
 
 
 

Cautions

Thermaltake recommends the following steps to be taken before using the Pacific series radiators and water blocks:

  • To ensure a clean loop, flush and rinse your radiators and water blocks with distilled water prior to use.
  • Do not use tap water or distilled water as your coolant, it may harm your loop and reduce performance.
  • It is strongly recommended to use market-proven pre-mix coolant, such as Thermaltake Coolant 1000, which offers great performance while protecting the entire liquid loop from corrosion.
  • Before storing your water cooling components, please clean, rinse, and dry. This will ensure a longer lifespan for your components.

Thermaltake recommends the following steps to be taken after completing your water loop setup:

  • It is strongly recommended to use market-proven pre-mix coolant, such as Thermaltake Coolant 1000, which offers great performance while preventing corrosion in the entire cooling system (copper, brass, nickel, aluminum, and steel).
  • Fill the reservoir with coolant and cycle the power on and off several times while the pump pushes the coolant into the loop.
  • DO NOT let the pump run dry. If no liquid is entering the pump, turn off your power immediately.
  • Fill the reservoir to the top to prevent air from entering the pump.
  • If necessary, tilt the system slightly from side to side to bleed the air out of the loop.
  • Place paper towels under fittings and joining points to test for leaks.
  • Run the loop with the fill port open for about 24 hours to completely bleed the air out of the loop.
  • Before starting, flush out your system properly to prevent any coolant or unwanted particles from sticking to your tubes, radiators, and other cooling components.
  • Coolant might fade over time.
その他の情報
P/N CL-W246-OS00TQ-A
カラー Turquoise
Capacity 1000 ml
Hazardous component 1,2-Propanediol< 6%
CAS 57-55-6
EC 200-338-0